Combining sampling, profiling, remote sensing and modelling to efficiently monitoring estuarine and coastal water quality

Monitoring of coastal and estuarine water quality has been traditionally performed by sampling with subsequent laboratory analysis. This has the disadvantages of low spatial and temporal resolution and high cost. In the last decades two alternative techniques have emerged to overcome this drawback: profiling and remote sensing. Profiling using multi-parameter sensors is now in a commercial stage. It can be used, tied to a boat, to obtain a quick “picture” of the system. The spatial resolution thus increases from single points to a line coincident with the boat track. The temporal resolution however remains unchanged since campaigns and resources involved are basically the same. The need for laboratory analysis was reduced but not eliminated because parameters like nutrients, microbiology or metals are still difficult to obtain with sensors and validation measurements are still needed. In the last years the improvement in satellite resolution has enabled its use for coastal and estuarine water monitoring. Although spatial coverage and resolution of satellite images in the present is already suitable to coastal and estuarine monitoring, temporal resolution is naturally limited to satellite passages and cloud cover. With this panorama the best approach to water monitoring is to integrate and combine data from all these sources. The natural tools to perform this integration are numerical models. Models benefit from the different sources of data to obtain a better calibration. After calibration they can be used to extend spatially and temporally the methods resolution. In Algarve (South of Portugal) a monitoring effort using this approach is being undertaken. The monitoring effort comprises five different locations including coastal waters, estuaries and coastal lagoons. The objective is to establish the base line situation to evaluate the impact of Waste Water Treatment Plants design and retrofitting. The field campaigns include monthly synoptic profiling, using an YSI 6600 multi-parameter system, laboratory analysis and fixed stations. The remote sensing uses ENVISAT\MERIS Level 2 Full Resolution data. This data is combined and used with the MOHID modelling system to obtain an integrate description of the systems. The results show the limitations of each method and the ability of the modelling system to integrate the results and to produce a comprehensive picture of the system.

Simulation of economic benefits achieved by water quality improvement for recreational and professional users, within the SPICOSSA SSA (SPICOSSA System Approach) 11 - Guadiana estuary ecosystem sic

Dissertação de Mestrado, Gestão da Água e da Costa, Faculdade de Ciências e Tecnologia, Universidade do Algarve, 2010

Advanced monitoring of South Portugal water bodies towards WFD

The challenge on implementation of the EU Water Framework Directive (WFD) fosters the development of new monitoring methods and approaches. It is now commonly accepted that the use of classical monitoring campaigns in discrete point is not sufficient to fully assess and describe a water body. Due to this the WFD promote the use of modelling techniques in surface waters to assist all phases of the process, from characterisation and establishment of reference conditions to identification of pressures and assessment of impact. The work presented in this communication is based on these principles. A classical monitoring of the water status of the main transitional water bodies of Algarve (south of Portugal) is combined with advanced in situ water profiling and hydrodynamic, water quality and ecological modelling of the systems to build a complete description of its state. This approach extends spatially and temporally the resolution of the classical point sampling. The methodology was applied during a 12 month program in Ria Formosa coastal lagoon, the Guadiana estuary and the Arade estuary. The synoptic profiling uses an YSI 6600 EDS multi-parameter system attached to a boat and a GPS receiver to produce monthly synoptic maps of the systems. This data extends the discrete point sampling with laboratory analysis performed monthly in several points of each water body. The point sampling is used to calibrate the profiling system and to include variables, such as nutrients, not measured by the sensors. A total of 1427 samplings were performed for physical and chemical parameters, chlorophyll and microbiologic contamination in the water column. This data is used to drive the hydrodynamic, transport and ecological modules of the MOHID water modelling system (www.mohid.com), enabling an integrate description of the water column.

Water use and conservation at the environmental protection area of Brilhante, Santa Catarina - Brazil

Dissertação mest., Gestão da Água e da Costa, Universidade do Algarve, 2008

Understanding the importance of sediments to water ouality in coastal shallow lagoons

The undesirable enrichment of water by nutrients may be a problem, especially in areas with restricted exchange with the sea. The tidal regime flushes the system and contributes for the removal of phytoplankton, favouring phytobenthos as the target of enhanced nutrients. Water samples were collected during the years of 2006 and 2007-08 for nutrients, chlorophyll a and dissolved oxygen. Sediment sample s were also collected for pore water nutrients and benthic chlorophyll a. From comparison with previous work, a decrease in the nitrogen concentration in the water column can be pointed out, which may indicate an improvement of the water quality. Pore water DAIN represents approximately 75% of the total DAIN of the whole lagoon. Benthic chlorophyll a concentrations were much larger than in the water column, representing around 99% of the total chlorophyll existent in the lagoon. Benthic microalgae play a relevant role in this system and therefore standard monitoring programs of the WFD, which do not consider this component, may fail to track nutrient-driven changes in primary producers. Dissolved oxygen concentration could be near critical levels during the summer (early in the morning), especially in the inner channels.

Beach quality assessment and management in the Sotavento (Eastern) Algarve, Portugal

The purpose of this study on beach quality assessment and management was to evaluate the quality of five beaches in the Algarve Sotavento region of Portugal and to identify beach users’ preferences and priorities regarding their visit to a beach. The Algarve is one of the country’s most internationally known regions and it is generally perceived as a major tourist destination. Because of the increasing level of tourists, there is a specific need to address beach quality, as overcrowding can result in excessive litter, reduce water quality and consequently reduce the socio-economic value of the area. The main methodology for the evaluation of the beach quality in this pilot project was the Bathing Area Registration and Evaluation framework (BARE), which recognizes five beach types (rural, remote, resort, urban and village) through five main priority issues of concern to beach users (water quality, scenery, litter, safety, facilities) and evaluates the beach quality, ranging from one (low) to five (high) stars. After overall bathing area classification, Quarteira-Vilamoura, Ilha do Farol, Ilha Deserta and Ilha da Armona received three-star rating and Quinta do Lago site obtained a one-star rating. The quantitative research data on beach users’ preferences and priorities was obtained through administration of 50 questionnaires per beach and showed that beach users at all sites expressed the need for improved cleanliness, safety and facilities on the beach. The BARE framework, together with the questionnaire surveys, allowed the identification of management priorities required to improve the quality of individual beaches and therefore increase income from tourism.